Cable Ties, Releasable Cable tie, fasteners, reusable cabletie, plenum rated tie, drywall anchors, fixings

An Award Winning Anchor For Use in Aircrete, also known as Autoclaved Aerated Concrete (AAC).

A unique fixing for Aircrete (AAC) Block which requires no pre-drilling and can be hammered home with ease into the block work providing a secure anchor for size 6-10 gauge screws The SQUARE ANCHORS patented design makes it streaks ahead of all other block work fixings. Use in any hard surface with a pre-drilled hole. This method creates fixings of extraordinary strength.

The new fast CABLE-TIE ANCHOR is the really strong fixing with no pre-drilling required for lightweight aerated concrete block, with superb pull out tolerances.

This simple hammer in ANCHOR provides the tradesman or handy amateur with a cost-effective solution for securing electrical trunking & cables onto lightweight aerated concrete block & brickwork.

The best Plasterboard/Wallboard fixing available on the market today.
Use for scew sizes 4-10. Also excellent for soft Aircrete (AAC) Block. 

An excellent and strong fixing for Plasterboard/Wallboard.
Great for use in Aircrete (AAC) with density less than 400kg/m3.
Designed to take a wider range of screw sizes than any other fixing on the market!

Bundling cables and wires has been a problem since the first electrical and telephone lines were laid. You now have no need to be concerned with this very necessary operation. Millepede Cable Rings will increase your company’s productivity by reducing installation time, decreasing waste and eliminating many safety hazards without disrupting the flow of energy.

The adjustable and reusable Millepede Cable Rings come in 4 sizes, (1/2 inch to 2 inches), as well as specialized versions for channel struts and distribution racks.

The Millepede Cable Rings are adaptable to just about any cabling situation, be it installing a new information system, wiring a building or even laying cable for a rock concert!

The Millepede Strut Ready Cable Rings will reduce your cost of overhead cabling. Where traditional channel strut clamps can take up to 6 minutes to install the Millepede Strut Ready Cable Rings can be installed in seconds. Simply insert and twist into the strut.

In seconds, not minutes, you have the clamp in place and ready to hang cable. No longer do you have to worry about screws or special tools to install strut clamps. If you want to add or remove a cable simply open the Mille-Strap n Strut™ to make the change and then close. Again this can be done in less than a minute.

Fast Trip Transient Surge Protection